Watering

Watering2018-11-15T15:05:09+00:00

Why is Watering So Important?

Tree Shade Umbrella by Design

Trees naturally form their design much like an umbrella and the purpose is to protect the transport roots from its’ trunk outward to the edge of the canopy or drip line. Trees don’t like wet feet, and excess water in this zone can cause root rot and numerous other health problems.

Watering under the tree canopy is not very beneficial for tree health care. So always water out beyond the tree canopy.

Newly planted trees- immediately after planting, all tree roots are in the original root ball area. Until new roots grow into the soil of the planting site, water the original root ball area and just beyond this area. The root ball area may dry out faster than the surrounding soil, so check the moisture in this area frequently for the first month or two after planting. A newly planted tree takes 1-2 years to become established. Larger container stock trees may take longer to become established than smaller stock.

How to Irrigate

You can apply water effectively using sprinklers, drip irrigation, or a hose running on the soil surface. Regardless of how you apply the water, follow these basic rules. Water deeply rather than frequently. Because most tree roots are found in the upper 18 – 24 inches of the soil, this is the zone that should be wetted up in each irrigation cycle. Each deep irrigation will meet a tree’s water needs for between 10 days to 2 weeks during the hottest part of the summer, depending on the tree species and soil type. Water the feeder root zone out beyond the canopy.

Stop watering when runoff starts. Soils high in clay accept water slowly, often as little as 1/4 inch per hour. Water infiltration is especially slow in compacted soils. If water starts to pool or run off, stop irrigating, let the water soak in, and start watering again. Repeat on/off cycles until you apply enough water to wet the soil to 18-24 inches. This may take a number of cycles over several consecutive days.

Don’t saturate the soil for long periods. Water displaces air in the soil, so long periods of soil saturation can suffocate growing roots. Take a long enough break between irrigation cycles to allow the free water to be absorbed. If in doubt, probe or dig to make sure that the soil isn’t soggy below the surface.

How much water does your tree need?

Tree irrigation needs change over time. The amount of irrigation your tree will need can be affected by:

  • Tree age – A newly planted tree will need more frequent irrigation than an established tree because its root system is more limited.
  • Root damage – An established tree that suffers root loss or damage (for instance, due to trenching within the root zone) may need additional irrigation until new roots grow to replace those that are destroyed.
  • Time of the year – The need for irrigation is greatest in mid to late summer, when temperatures are the highest and most of the moisture stored in the soil over the winter has been depleted.
  • Weather conditions – In drought years, soil moisture is used up earlier in the season, so the period of peak water need is longer. Some trees that do not normally need irrigation may benefit from irrigation in drought years. In very wet years, irrigation may not be needed until early summer or later.
  • Soil conditions – Water used by trees is stored in the soil. Soil type, depth, and condition influence how much water can be stored in the soil, and consequently how often you may need to water. Soils that have more clay hold more water and can be irrigated less frequently. Sandy soils hold relatively little water and need more frequent irrigation.
  • Species – Some tree species require no additional irrigation once established, whereas others will do poorly without consistent irrigation throughout the summer.